Recycle your Computers & Technology with us.

Dropped my phone in water!

Posted By : of Data Doctors on September 10, 2009

Follow us on Facebook   Follow us on Twitter   Follow us on LinkedIn

Let Data Doctors be your personal IT department today

What can be done if I dropped my smartphone in water?

- Craig

This question was answered on September 10, 2009. Much of the information contained herein may have changed since posting.

As everyone knows, electronics and moisture are not a good mix and what you do in the early stages after introducing your favorite device to liquid is critical.

The first thing to do is turn it off and take out the battery (iPhone users don’t have the battery removal option, so turning it off is critical) The biggest mistake that’s made in these panic situations is repeatedly trying to get the device to power up hoping that everything will be ok; each attempt could be your last!

Your best chances of recovery will be to not turn it back on until you are absolutely certain that all of the moisture has been removed or has evaporated.

Liquid is a fantastic conductor of electrical energy and can easily cause an electronic ‘short’, which causes electricity to flow across circuitry in improper channels (thus the term ‘short circuit’).

If your smartphone has a memory or sim card, be sure to remove it as well as the data stored on it could also be at risk.

Depending upon the amount of time that it was left on while wet, you may be able to simply get the device cleared of the water and have it work perfectly.

Once the battery has been removed, open or remove any other panels or slots then wipe down all the surfaces with an absorbent paper or cloth towel Rotate it various directions to see if you can coax any large collections of water out of the unit.

The next step is to either let the device sit in a warm and dry environment (like on top of a stereo receiver or cable converter box, but away from the open vents) so the liquid can evaporate; usually within 12 to 24 hours.

If you want to accelerate the evaporation, a long standing trick in electronic circles is to put the device in a sealed container filled with uncooked rice then place it in a warm environment like in your car in summer months or in the afore mentioned locations.

For those that have the misfortune of dropping a device into a liquid other than water, the task will be more involved, especially if the liquid has a sticky residue like soda or coffee.

In those cases, the electronic surfaces that have come in contact with the sticky liquid will have to be cleaned with either isopropyl rubbing alcohol or a plastic safe electronic spray cleaner.

In order to do this, it will typically require that you take the device apart to reach the surfaces that need to be cleaned.

As with the water, if you don’t clean off the sticky residue even after it’s had enough time to evaporate, you risk the chances of the residue shorting out the circuitry as well.

If you don’t know how to take apart your device, you can use one the more useful technical resources that will show you via video: YouTube!

If you search for your specific device with the term ‘take apart’ in front of it, you will likely found dozens of videos that show the step-by-step process for taking the unit apart so you can completely clean the electronics of the sticky residue.

About the author

Posted by of Data Doctors on September 10, 2009

Need Help with this Issue?

We help people with technology! It's what we do.
Contact or Schedule an Appointment with a location for help!